Demilec Insulation Removal & Replacement in Whitney: What to Know First
We remove and replace failing Demilec spray foam and injection foam insulation throughout Whitney, and most jobs run one to two days from tear-out to finished, code-compliant insulation. Expect honest numbers before we start: attic spray foam removal in Whitney typically runs $1,400 to $4,200 depending on square footage and how deep the foam is, and we give you the full figure in writing before anyone touches your attic. No trip charge inside our service county, and a free second opinion on any written estimate you’ve already received.
This page is for Whitney homeowners who have Demilec foam in the attic, walls, or rim joists and are dealing with shrinkage, off-gassing, hidden moisture, or a failed inspection. We’re an independent Demilec service provider, not Demo’s factory rep, and we’ll tell you plainly what can be saved and what needs to go. Call (866) 810-4177 and a live person picks up – day, night, or weekend.
How Demilec Products Fail – and How We Fix Them
Demilec foam is good material installed right. The calls we get in Whitney almost always trace back to one of five patterns, and each one looks slightly different in the attic than cheaper foams do.
- HeatShield / HeatLok open-cell foam gone spongy or crumbling. Open-cell foam in a Whitney attic takes brutal summer heat cycling, and after 8 to 15 years it can lose adhesion and turn soft or powder where it meets the roof deck. We tested one home near Whitney Ranch last spring where the foam pulled away cleanly by hand across half the attic. When that happens it isn’t holding air anymore and has to come out.
- Soya / SucraSeal soy-based foam with a failed seal. The soy-blend lines pick up a faint odor homeowners sometimes mistake for a chemical problem; the real cause is usually moisture trapped behind lifted foam. We remove the loose sections, find the moisture source (usually roof or bath fan), then re-insulate once the deck is dry.
- Sealection 500 in crawl spaces and rim joists taking on water. Open-cell Sealection is vapor-permeable, which is fine in dry attics but a problem when the crawl space is damp. We’ve pulled mushy Sealection out of Whitney crawl spaces where a downspout had been dumping into the foundation for years. Removal plus crawl space encapsulation fixes the root cause.
- Closed-cell foam (Heatlok series) applied too thick or too thin. Thin passes don’t insulate to spec; thick passes trap moisture against the roof deck and cause hidden deck rot. Both are installation failures, and both are reasons a homeowner calls us after a failed energy audit. We remove the bad pass, dry the deck, and rebuild it properly.
- Foam sprayed over vermiculite or old batt insulation. We see this most in older Whitney homes where a previous contractor sprayed foam directly on top of 1970s-era material. That buries the old insulation, sometimes asbestos-bearing vermiculite, and locks in moisture. We remove everything down to the deck so the whole assembly can be rebuilt correctly.
Our Demilec Insulation Removal & Replacement Process
A Demilec removal job in Whitney isn’t like pulling fiberglass batts. Here’s what it looks like from your first call:
- 1
On-site diagnosis. We get in the attic or crawl space, measure foam depth, check adhesion with a screwdriver test, and look for moisture staining on the deck and top plates. You get photos and a written scope.
- 2
Air quality and safety check. If there’s any chance vermiculite or suspect material is underneath, we flag it and advise on testing before removal. We never cut into that material without a plan.
- 3
Contained removal. Mesh and plastic contain the work zone, and a HEPA vacuum runs the whole time. Demilec foam comes out in chunks; we bag and haul it so your house is cleaner than when we arrived.
- 4
Deck inspection and air sealing. Once the foam is gone we inspect the roof deck for rot and seal around every penetration, top plate, and recessed light before anything new goes in.
- 5
Replacement with the right product. We match the material to the assembly: Demilec or Icynene for spray foam, Owens Corning or Knauf for blown-in, GreenFiber for a cellulose option, Rockwool where fire performance matters, and CertainTeed or Johns Manville batts where they’re the right call. No upselling foam into a spot that doesn’t want it.
- 6
Final walkthrough and guarantee. We show you the finished work, leave the manufacturer spec sheets, and back the job with the Done Right Promise – lifetime workmanship. If it’s not right, we come back and make it right.
What Demilec Insulation Removal & Replacement Costs in Whitney
Whitney attic spray foam removal typically runs $1,400 to $4,200, with most single-story attics landing around $2,200 to $3,000. That includes removal, haul-away, and deck prep but not replacement. Here’s how the numbers break down:
| Job | Typical Whitney Range |
|---|---|
| Open-cell Demilec removal (attic, 1,000-1,500 sq ft) | $1,400 – $2,800 |
| Closed-cell Demilec removal (thicker, denser) | $2,200 – $4,200 |
| Crawl space Demilec removal (rim joists and walls) | $1,200 – $2,600 |
| Replacement with blown-in (Owens Corning, Knauf, GreenFiber) | $1,800 – $3,400 |
| Replacement with new spray foam (Demilec / Icynene) | $3,200 – $6,500 |
| Crawl space encapsulation after removal | $3,500 – $7,500 |
| Air sealing add-on | $400 – $900 |
What moves price: attic square footage, foam thickness, whether old insulation is buried underneath, crawl space access, and any rot repair needed. We give you a written quote from a free walkthrough – no surprises. Ask for the free second opinion on any other written estimate, and note the $40 off any repair over $200, no trip charge in our county, and 10% off for seniors and veterans, always.
Why Whitney Homeowners Call Walt’s Insulation Whitney for Demilec Work
We’re the one down the road. Locally owned, owner-operated, published address, license number, and phones answered by a live person 24/7 – not an 800 number that takes a message. Our technicians have up to 26 years of experience, and they’ve pulled Demilec foam out of attics in Whitney Ranch, Paradise, and Sunrise Manor enough times to know when a section can be saved and when it can’t.
Every job is covered by our Done Right Promise: lifetime workmanship, no runaround. We also service Reflectix alongside Demilec and the other brands in our lineup, so if your attic has mixed materials from past contractors, we handle the whole assembly in one visit. Background-checked, uniformed technicians on every job. Upfront pricing, no trip charge inside the county.
FAQs
Demilec’s product warranty typically covers manufacturing defects, not installation failures, and removal by an independent contractor doesn’t void a defect claim you might still have. In practice, most Whitney jobs we take on are past any meaningful warranty window or were installed incorrectly to begin with – so the question is really what the right going-forward solution is. Call (866) 810-4177 and we’ll walk through your paperwork with you.
Same-week scheduling is standard, and we usually walk through a Whitney attic within two to five business days of your call. Emergency situations – water intrusion, pest damage, an active roof leak into foam – get same-day response when we can get a tech out. Phones are answered live 24/7, so call any time and we’ll get the details and a callback scheduled. Free estimates.
Repair only makes sense when the foam is intact and the failure is a localized seal, small section, or unrelated moisture problem. Once open-cell foam has lost adhesion across more than about 20% of the attic or soaked up water, replacement is almost always cheaper over the next decade because patch repairs keep failing. We’ll give you both numbers in writing if there’s any doubt. Call (866) 810-4177 for a free walkthrough and a same-day estimate.
Yes – the work zone is contained with mesh and plastic and a HEPA vacuum runs throughout removal, so dust stays in the attic, not in your living space. We’ve pulled foam from Whitney homes with newborns and pets in the house using this method. The full job, from containment to cleanup, usually takes one to two days.
We handle the full Demilec line – HeatLok, HeatShield, Sealection 500, Soya, and SucraSeal – in attics, rim joists, crawl spaces, and walls. If you have another brand underneath, including Reflectix radiant barrier, we’ll take the whole assembly apart and rebuild it correctly in one job. Call for a free estimate and a written scope.
Ready for a Straight Answer on Your Demilec Insulation?
If you’re in Whitney and dealing with failing Demilec foam, don’t sit on it – moisture trapped in bad foam does more damage the longer it sits. Call (866) 810-4177 for a free estimate and a written scope. A live person answers every time. No trip charge inside our service county, $40 off any repair over $200, and a permanent 10% discount for seniors and veterans. Every job is backed by the Done Right Promise.
Written by the team at Walt’s Insulation Whitney, serving Whitney and nearby areas.